Table of Contents
Advertisement
ASSEMBLING YOUR UNIT
TOOLS
REQUIRED
Socket wrench set
A pair of pliers
Screwdrivers (Phillips head)
CHUTE
1.
ASSEMBLY
2
.
3.
Install discharge chute on the rotating ring located on the auger
housing. Secure with three 5/16 inch carriage bolts, flat wash¬
ers and nylok nuts. Install the rear bolt first for easier align¬
ment. You will find the hardware in the parts bag. See figure 1.
Make sure that for all three bolts, the bolt head goes inside the
rotating ring, and the washer and the nut are on the outside.
Tighten bolts securely with the wrench.
Lift up the folding handle and align it with the lower handle until
it clicks into place. Tighten the wing nuts securely.
FUEL & OIL
MIXTURE
Note: Your snow thrower unit uses a two cycle engine that requires
a mixture of gasoline and oil for lubrication of bearings and other
moving parts.
Mix the gasoline and oil in a clean gasoline container.
Always use fresh, unleaded, winter grade gasoline;
never use 'stale' gasoline left over from last season or
stored for 30 days or longer.
Use the correct fuel/oil mix to prevent engine dam¬
age. Follow the chart below.
FUEL/OIL MIXTURE CHART (50:11
u.s.
IMPERIAL
METRIC
Gasoline
Gallons
2 Cycle Oil
Ounces
Gasoline
Gallons
2 Cycle Oil
Ounces
Gasoline
Liters
2 Cycle Oil
ml.
1
2.5
1
2.8
4
80
2
5
2
5.6
8
160
5
13
5
14.1
20
400
A
WARNING
•
Handle gaso-j
line carefully.]
Remember
j
that it is
j
highly flam- ]
mable.
I
• Careless use ]
or handling of
^''gasoline
: could
cause
fire
hazard and
result in dam¬
age to your
i
person and/or
property.
;
• Always fill
i
gasoline con¬
tainer out¬
doors.
4
Advertisement
Table of Contents
