Table of Contents
Advertisement
CARBURE¬
TOR
5.
To reduce or extend the length of the
clutch cable, adjust the nuts on the clutch
cable. See figure 8. Reducing the cable
length will increase idler pulley pressure
on the belt.
Use extreme caution when mak¬
ing adjustments that require
engine to be running.
Keep hands, feet, hair and loose
clothing away from any moving
parts.
6.
Start the engine and pull back on
clutch control to operate the auger.
Release the clutch control and check to
be sure that the auger stops turning.
7.
Cable must have some slack when
the clutch control is released. If the
auger continues to turn after the
clutch control is released, the cable is too tight. Adjust the nuts accordingly.
8.
Reinstall the engine cover/cowling and secure with the correct hardware.
• The carburetor is properly calibrated and pre-set at the factory for efficient cold
weather operation. There are no adjusting screws on the carburetor.
• If you feel, during operation of the snow thrower, that the carburetor is not providing
adequate fuel supply to the engine, contact your nearest Authorized Tecumseh Ser¬
vice Outlet for service.
10
Advertisement
Table of Contents
