Toro eTimeCutter eMR4275 Operator's Manual page 55

Leveling the Mower Deck (continued)
3. Position 1 blade front-to-rear.
4. Measure at locations
surface to the cutting edge of the blade tips
The front blade tip should be 1.6 to 7.9 mm (1/
16 to 5/16 inch) lower than the rear blade tip. If
the measurement is not correct, adjust the
front-to-rear level.
Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or remove them completely for this procedure.
2. Set the height-of-cut lever to the 76 mm (3 inch) position.
3. Place 2 blocks, each having a thickness of 6.6 cm (2-5/8 inches), under each side of the
front edge of the deck.
Do not place the blocks under the anti-scalp roller brackets.
Block—6.6 cm (2-5/8 inches)
3445-793A
and from a level
IMPORTANT
G448682
Page 5–11
.
G440749
Block—7.3 cm (2-7/8 inches)
Maintenance: Mower-Deck Maintenance