Toro eTimeCutter eMR4275 Operator's Manual page 41

Charging the Battery Packs (continued)
2. Line up the cavity in the battery pack with the tongue on the charger.
3. Slide the battery pack into the charger until it is fully seated
4. Wait for the battery pack(s) to charge. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
light
Off
Yellow
Green
blinking
Green
Red
Red
blinking
If multiple battery packs are connected to the charger, you can switch between 2
charging modes by pressing the A/B button on the side of the charger.
• Serial charging (Mode A): Fully charges 1 battery pack at a time; once fully charged,
the next battery starts charging. This results in individual fully-charged batteries
faster.
• Parallel charging (Mode B): All connected battery packs are sequentially charged to
the same level. This results in all connected batteries being evenly charged.
The battery can be left on the charger for short periods between uses.
If the battery will not be used for longer periods, remove the battery from the charger.
5. To remove the battery pack, slide the battery pack out of the charger.
3445-793A
Indicates
No battery pack inserted
Battery pack is on standby while other battery pack(s) are charging
Battery pack is charging
Battery pack is charged
Battery pack and/or battery charger is over or under the appropriate temperature
range
Battery pack charging fault; refer to Troubleshooting
IMPORTANT
Page 4–18 Operation: After Operation