Replacing The Processor - Gateway 450RGH Service Manual

Replacing Gateway Notebook Components

Replacing the processor

Tips & Tricks
You do not need to disconnect the
keyboard cable from the system board.
36
Tools you need to complete this task:
Flat-blade driver
Phillips #0 screwdriver
Additional materials you may need to complete this task:
X-23-7762 thermal grease
■
Screws removed during this task:
4 chrome 2.5 × 2.5 mm
(keyboard)
To replace the processor:
Complete the steps in
1
Turn the notebook over so the top is facing up.
2
Remove the keyboard cover by following the instructions in
3
the keyboard cover" on page
Open the keyboard compartment by following the instructions in
4
"Replacing the keyboard" on page
Remove the cooling assembly by following the instructions in
5
the cooling assembly" on page
- OR -
4 chrome 2.5 × 4 mm
(cooling assembly)
"Preparing the notebook" on page
19.
21.
31.
www.gateway.com
Scribe or non-marring tool
6.
"Replacing
"Replacing