Wiring For Single Use - Furuno PR-241 Installation Manual

The mounting procedure is as follows:
1. Referring to the outline drawing at the back of this manual, make four pilot holes
for self-tapping screws (4x16, local supply) in the mounting location.
2. Place the unit in a fixed position and align the screw holes.
3. Secure the unit by tightening the self-tapping screws.

2. WIRING FOR SINGLE USE

Fabrication
Use the following crimp-on lugs (local supply) and cables or equivalent (local supply) for
connection with the power supply unit.
• Power cable: TPYC-1.5, DPYC-1.5
• Crimp-on lugs (see below figure): FV2-P4K
CAUTION
To prevent noise and interference,
separate the AC IN, DC IN and DC OUT
cables of this unit from connected
equipment's cables.
7.0 mm
FV2-P4K (or equivalent)
3
Self-tapping
screws (4x16, 4 pcs.)