4. HOW TO USE THE UNIT
Use the power switch to turn this unit on.
Power Switch
After turning on the power switch, the LED lights up as follows:
• AC is selected as the input: Green
• Battery is selected as the input: White
• No Input: OFF
Procedure in dual use
Note 1: Do not use the ID SW and Terminate SW of this unit when using this unit in
dual.
Note 2: To avoid breaking the breaker, set the total current to 20A or less before start-
ing the unit up.
The procedure in dual use is as follows:
Note: If you do not follow this procedure, the breaker may break.
1. Turn on the main switch.
2. Turn on the sub switch.
3. Turn on the ship's main switch.
Maintenance
• If the LED does not turn on when the power switch is turned on, contact your local
dealer.
• If the breaker breaks, check the cause and take corrective action before resetting
the breaker.
• If the breaker is cut off again after doing above, contact your local dealer.
LED
9
Breaker