Table of Contents
Advertisement
Power On Status
• Decide to select working status of TV Set when turn on main power.
• You can set with PWR, STD, LST.
•
PWR
always make TV set On status when turn on main power .
STD
•
make Stand-by status when turn on main power.
•
LST
make TVSet work like previous power status. As same concept as Power Backup mode; If main power
were turned off in
Power On
by status, TVSet would work in Stand-by status.
Volume (0 ≤ Min ≤ Start ≤ Max ≤ 100)
• Decide to apply volume policy of
as
On
(Work) or
Off
(Do Not Work).
Start Volume
This entry sets the start volume level when is power on.
• The level is specified as a number between minimum volume to maximum value.
(Min ≤ Start ≤ Max)
• The default setting is
• When enabled, if the value is lower then the minimum specified in the minimum volume entry,
the minimum volume entry must be used.
• When enabled, if the value is larger then the maximum specified in the maximum volume entry,
the maximum volume value must be used.
• Access to a volume in
HotelMode
(Enable) and
Maximum Volume
This entry sets the
• The level is specified as a number between
• If the command volume up to higher than maximum volume is received, that should be ignored.
• The default value is 100.
Minimum Volume
This entry sets the
• The level is specified as a number between
• If the command volume down to lower than minimum volume is received, that should be
ignored.
• The default value is 0.
status, TVSet would work in On status. If main power were turned off in Stand-
Start
Volume,
Maximum Volume
Off
(disabled).
Timer Power On
of User Menu must be fixed to start volume when
Start Volume (Off, 0
Maximum Volume
level the set.
Minimum Volume
level the set will produce.
Minimum Volume
and
~ 100) were set simultaneously.
Minimum Volume
to 100. (Min ≤ Max ≤ 100)
0
Maximum
Volume. (0 ≤ Min ≤ Max)
to
5
HTNG
Advertisement
Table of Contents
