Table of Contents
Advertisement
4 Disassembly and Reassembly
4, Turn Upper Frame Ass*y C upside down and
Remove left side screw [e] on Platen Paper
remove three screws [d]. Remove Stamp
Guide E. This screw connects Platen Paper
Paper Guide Ass' y D from Upper Frame Ass* y
Guide Ass*y E to Stamp Paper Guide Ass* y D.
C.
See Figure 4-4, below.
Figure 4-3. Stamp Paper Guide Removal
Figure 4-4. Platen Paper Guide Removal
5.
4-2 Reassembly
Caution: Adjust Head Gap (see Alignments and Adjustments chapter) before returning ECR to owner.
4-2-1
ERP-300V Printer Reassembly
1. Position Platen Paper Guide Ass* y E on Stamp
Paper Guide Ass' y D and replace screw [e] (see
Figure 4-4, above).
2. With Upper Frame Ass*y C upside down,
position Stamp Paper Guide Ass' y D and
replace three screws [d] (see Figure 4-3, above).
3. Position Upper Frame Ass*y C on Lower
Frame Ass*y | and replace four screws [c] (see
Figure 4-5, to the right).
Caution:
Locate Stamp Pusher F on hatched
area as shown in the figure.
4. Position Ribbon Frame B on Lower Frame
Ass*y | and replace two screws [}] (see Figure
4-1, above).
5. Position Cover A on Upper Frame Ass*y C and
replace four screws [8].
Figure 4-5. Stamp Pusher Position
a
ee
EI
a
a
re
4-2
Samsung
SER-6500 / SER-6500F / SER-6540 / SER-6540F
Advertisement
Table of Contents
