Table of Contents
Advertisement
DISPLAY STATION CHECKOUT
Before doing the display station checkout on the next page, do the following:
• Make sure that your display station is connected to a system, a 5251 Model
2 or 12 Display Station, or another work station.
• Make sure that the system, 5251 Model 2 or 12 Display Station, or work
station to which your display station is connected is operating.
Note: On System/38, the work station controller must also be operating.
If the cable attached to socket 1 on your display station comes directly from a
system or a 5251 Model 2 or 12, go to step 1 on the next page.
If the cable attached to socket 1 on your display station comes directly from a
work station (not a system or a 5251 Model 2 or 12), do the following:
• Make sure that the preceding work station(s) is set up and is powered on.
• If the last work station in your series has a Terminator switch, make
sure it is set to
1.
The Terminator switch on all other work stations
must be set to
2.
(See Appendix A in this manual for the location of
the Terminator switches on the work stations.)
is from
a
system, a
5251 Model
2 or 12, or
another
work station.
These are the preceding work
stations cabled together.
/
Terminator switches must be set to
2.
This is the last work
station in a series.
If it has a Terminator
switch, it must be set
to 1.
- - - - - - - - - - - E x a m p l e O n l y - - - - - - - - - - - - -
Connecting the Display Station
21
Advertisement
Table of Contents
