JVC GX-N7E Service Manual page 6

H
i
[1] HOW TO SUPPLY POWER
= When connected to JVC compact VTR HR-C3.
In this case, it is possible to switch the VTR on from the
@ When connected to a VTR with a camera connection
terminal. (See 11] WHEN THE VTR HAS A CAMERA
CONNECTION TERMINAL in "HOW TO CONNECT camera,
TO A VTR" section on page 6E.)
Power is supplied to the camera when the VTR
is
@ Push POWER button @ to switch the VIR
switched on. on.
@ When connected to a VTR with no camera connection
0)
® Push it again to switch the VTR off.
terminal. (See page 6E.)
Power is supplied to the camera when the VTR
is switched on.
Power is supplied to the camera when the AC adaptor is
switched on.
Notes:
© Power supply to the camera may be different according
only when connected to JVC compact VTR HR-C3.
to the type of VTR connected. Refer to the VTR's
instruction manua! for details.
For standard shooting, set IRIS CONTROL switch ®
to position @
tion to select the manual [RIS CONTROL
mode. Then turn IRIS CONTROL knob @®
in either direction (Refer to the following de-
scription of IRIS CONTROL knob @®) to
adjust the iris manually.
Using IRIS CONTROL knob ®
Turn ERIS CONTROL knob @® in direction
@ to make the picture darker {by closing the
aperture}.
@ side :
a BE=
Position + : Set BLC switch @ to the "+" position to allow the iris to open by approxi-
mately 1/2 an f-stop above the standard AUTO IRIS setting. Use this func-
tion when the subject is too dark and the background is too bright.
+
t 0
PositionO : Set BLC switch
@ to the "Q'
position to release the BLC function or
restore the standard AUTO IRIS CONTROL function.
For standard shooting, set FOCUS switch @ to position Q.
Infrared transmitter
Infrared receiver
~9E —