Yamaha DX9 Operating Manual page 23

Using MIDI.
• Real-Time Control
1. Sequencer Controlled Automatic Performance
With the system shown in figure 1, let us use the DX9
as synthesizer A, and the DX7 as synthesizer B. Specify
the DX9 receiving channel as 1, and the DX7 receiving
channel as 2. This will enable automatic performance
under sequencer control.
2. Remote Control Performance
Hooking up the remote keyboard KX 1 to a DX9 as shown
in the figure, will enable you to remotely control the DX9
from the KX1 keyboard. In addition, by connecting a DX9
and a DX7, the DX7 can be contro lled from the DX9
keyboard. The DX9's send channe l number should also be
specified as 1.
I
!
OUT
IN
KX1
DX9
(DX9)
(DX7)
• Transmit System Information
1. Transmit Single Voice Data
When the display appears as shown in the figure, press
the voice number key for the voice you wish to transmit.
The correspo nding voice data will be output from MIDI
OUT.
FUNCTION CONTROL
SYS INFO HUH I L
in this condition
MEMORY
SELECT
Press the voice number key for
the voice you wish to transmit.
2. Transmit Voice Data for All 20 Voices
Press
CJ
when the display appears as shown in the
upper area of the figure. The display will change to that
shown in lower area of the figure. Pressing
[QEJ_]
will
cause the voice data for all 20 voices to be output from
MIDI OUT.
<22>
FUNCTION CONTROL
SYS INFO H' . .JH I L
in this condition
Pressing the
the display will change to
E~
,,,
YES
Pressing the
FUNCTION CONTROL
t·liDI
TRHNSt·liT?
1+1~
r key, the voice data for all 20 voices
0
to be output from ch.1.
ON
3. Transmit Voice or FUNCTION Parameters
When the display reads "SYS INFO AVA IL", press
either
I
EDIT
I
or
I
FUNCTION
I .
Pressing the key co r-
responding to the parameter that you wish to transmit wi ll
output the data for that parameter from MID I OUT.
FUNCTION CUNTROL. . ..
SVS I
t·~FO HI.IR
I
l_
m th1s cond1t10n
Press either
Press the voice number
key for the voice or
function parameters you EDIT/
COMPARE
L~·,
r~ ,,,~'·"·
'""'mi<
Note: For all of the above, the transmit channe l number
of the DX9 is 1.
• Receiving System Information
Select the same number for both the receive and the trans-
mit channels. Whenthedisplayreads"SYS INFO AVAIL",
the instrument will be ready to receive system information.
1. Receiving Single Voice Data
After receiving the voice data for a single voice, the voice
data will be held in the memory of the buffer and the
voice number display shows "0".
2. Receiving the Voice Data for all 20 Voices
Switching the PROTECT off for the memory, will
ca use the voice data for all 20 voices to be memorized
into the internal memory.
3. Receiving Voice or FUNCTION Parameters
When receiving this information, the unit will vary the
data for that particular parameter.