Yamaha DX9 Operating Manual page 19

• Connecting a Cassette Recorder
Connect the cassette recorder to the DX9 using the
supplied connection cable as follows:
Connections
Handytype
Cassette tape
recorder
t
to the EARPHONE jack
-==OdlJTI;m!m
White cord
to the MIC jack
~ 1 _R_ed_c_o_rd_-+--'
to the REMOTE jack
Black cord
1) Connect the DX9 "IN" terminal and the cassette
recorder's "EARPHONE" or "HEADPHONE"
jack with the white cord.
2) Connect the DX9 "OUT" terminal and the cas-
sette recorder's "MIC" jack with the red cord.
3) Connect the DX9 "REMOTE" terminal and the
cassette recorder's "REMOTE" terminal with the
black cord. (No connection required for cassette
recorders that do not have a REMOTE terminal)
<
18>
3. SAVE
The SAVE functions saves all 20 voices in the internal
memory to an external cassette tape.
1) Make sure the cassette recorder is connected properly
and load the cassette tape to which you wish to SAVE
the DX9's internal voices.
2) Enter the FUNCTION mode and set the display to read
"SAVE TO TAPE?" using the ISAV E/VERIFY I key.
3) Press the I YES I key and the display will read "from
MEM to TAPE all ready?". Press the iYESI key again
and the "ready" portion of the display will disappear
and the SAVE operation will begin.
Press the
Press the
YES
E~J
ON
v
Press the
key
FUNCTION
CONTROL
SRl.JE TO
T~F'E · - : : ·
froM MEM to TRPE
a
11
t-
e.~d·=e
1
:S"
j
fror"l t1EM
to
TRPE
b~keyagain
all
ON
1,._-------t
The "ready" portion will disappear
and Save operation will begin.
4) After a brief pause a number "1" will appear in place of
"ready" indicating that the first voice is being saved.
Each voice is indi cated as it is
saved ( 1-20).
When the SAVE operation is completed, the display wil l
read "VERIFY TAPE ready?"
4. VERIFY
The VERIFY funcion checks to make sure that all the
voices were properly saved on external cassette tape by a
SAVE operation. It is advisable to always use the VER IF Y
function after saving a group of voices to prevent accidental
loss of voices due to improper connections or other faults
during the SAVE process. Also, be sure to VERIFY the
same group of voices that were saved or an ERROR mes-
sage will result.
1) Set the cassette tape to the beginning of the voice
group to be verified.
2) Make sure that the cassette recorder headphone jack
is properly connected to the DX9.
3) Press the cassette recorder PLAY button, then press
the DX9
I
YES
I
key The tape will begin to play and a
pi lot tone wi II be heard.