Yamaha DX9 Operating Manual page 21

• If an ERROR message is displayed during LOAD
or VERIFY
If t hi s happens th e tape w ill stop. Rewi nd t he cassette
t ape to the beginn ing of the voice group, adjust the
leve l (vo lu me) on you r tape recorder, and repeat the
LO A D operat ion.
Si mp ly increasing or dec reasin g t he output level of
yo ur cassette recorder shoul d correct the error , but it
may take a few tries to f in d the appropriate level.
If t h is does not co rrect t he prob lem, the cause may
be one of the following:
VERIFY ERROR
1) The voices were not properly saved to excessive
speed f luct uation in your cassette recorder.
2) Improper record level (this applies to recorders
that have a record leve l co ntrol).
LOAD ERROR
1)
Excessive speed fluctuation in your cassette re-
corder.
2) Erroneous data recorded on data tape .
• Let's keep a record of this voice for future reference .
At the end of th is manual you will find a voice data list.
Use this list to record the values of every parameter
used . Make co pies of this list and use t hem to record t he
parameters of any new voices you create yourself. This
will be usef u l to restore vo ices that have been erased,
and w ill serve as an exce ll ent guide fo r creati ng new
vo ices.
<20>
2) LOADing a single voi ce .
This function loads any single voice from within a voice
group, and operates basically in the same way as for
loading a voice group . Instead of press ing the
I
LOAD
I
key, press the
I
LOAD Sl NG LEikey .
( 1)
Make sure the cassette recorder is properly con-
nected and set the tape to the beginning of the voice
group that contains the desired voice.
(2) Press t he
I
LOAD SI NG L E
I
key and then the
I
YES
I
key and the display wi!l read "from TAPE to BUF
single? (1-20)". The DX9 is asking you for the number
of the desired voice.
(3) Press the preset key corresponding to the number
of the desired voice and the display will respo nd with
the chosen voice number and "ready? " .
ES
j
frcw1
TRF'E
t.r-~
E:UF
10~~
Press mg ;:.
i
n9l
e
v3
r·e. : td'::l?
-v
V OI Ce numbe r
(4)
Press theiYESikey and the tape will begin playback.
The pilot tone will be heard.
(5) Set the cassette 1·ecorder volume control so that the
pilot to ne is at a comfortable listening level .
(6) The display counts down the voices in the group,
and the DX9 PLAY mode is engaged when the desired
voice has been loaded. T he voice number display shows
"0". T he loaded voice must then be stored in any preset
number according to the STORE instructions on page 1 7.