Table of Contents
Advertisement
g
Remote control unit
The backlight fiashes five times during nor-
mal operation.
Subwoofer volume cannot be adjusted.
Certain inputs cannot
be selected
using
the remote control.
The batteries are nearing exhaustion.
Subwoofer is OFF.
No preset codes registered at for the respec-
tive input(s).
Remote control operation is not possible.
For the U.S.A.
FCC WARNING
change or modification is, made.
NOTE:
.
é
~—Reorient
or relocate the receiving antenna.
The remote control is set to a different opera-
tion mode.
Batteries are exhausted.
The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
The audio cords and system contro! cords are
not connected properly.
No software is loaded in the source compo-
nent.
An attempt is made to play a tape which is
being recorded in the cassette deck.
The remote control has not been set to the
operation mode for the component you wish
to control.
The remote
control
is in the Room B (A)
operation mode.
— ~ Increase the separation between
the equipment and receiver.
-~ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
~— Consult the dealer or an experienced radio / TV technician for help.
e Turn the subwoofer ON.
[ Memory back up function
the AC outlet for approximately 3 days.
* Power mode.
* Input selector settings.
«Volume level
¢ Broadcast band.
¢ Frequency setting.
* Preset stations.
Nos
Please note that the following items will be deleted from
the unit's memory if the power cord is disconnected from
* Settings made using OSD (like SURROUND
SET UP).
For the U.S.A.
1OSOVR
[En/K}
e Replace with new batteries to preserve the
currently registered setup information.
~ 16.
~ 18.
Register a preset code or Non-!R code at the
respective input(s).
38
Press VIDEO,
AUDIO,
or TV to select the
approriate operation mode.
Replace with new batteries. If the backup is
exhasted before you can replace the batter-
ies, redo the setup procedure.
Operate the remote control unit within the
controllabie range.
~ 26. - 3H
Connect properly referring to "Setting up the
system".
s.
Place software in the source component you
want to play.
Wait until recording has completed.
Press the VIDEO, AUDIO, or TV key to activate
the operation mode for the component you
want to control before operation.
Change the operation mode.
-(45-
— 41
Note to CATV system installer:
This reminder
is provided
to call the CATV
system
installer's
attention to Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shalt be connected to the grounding system of the building, as close
to the point of cable entry as practical.
Advertisement
Table of Contents
