Advertisement
Available languages
Available languages
It is practical to begin this procedure with
At this stage, the on-screen channel pro-
channel
programme
number
'*1"; this
gramme
number
display will turn yellow
| procedure
can
be
repeated
up
to the
from green to indicate the AFT has been dis-
maximum of "39".
engaged.
Switching
the AFT
of the Above-
mentioned Channel On Again.
1. Select the required channel for which the
AFT is to be switched on.
2. Set the band selector to the ''VHF"' or
"UHF"' position, then press a tuning but-
ton (A or V) momentarily.
3. Set the band selector to the ''NORM"' po-
Switching Off the AFT (Automatic
sition to switch on the AFT.
Fine Tuning) of a Channel After All
Channels Have Been Preset.
1. Select the required channel for which
the AFT is to be switched off.
2. Set the band selector to the "NORM"
position, then press a tuning button (A
or V)to switch off the AFT. Fine tune the
channel according to your preference.
When the tuning button is released, the
AFT will remain off.
Fine Tuning
Set the band selector to the ""NORM'' (Nor-
mal) position, then press a tuning button (A
or V) to adjust the picture quality to an op-
timum
level under weak signal conditions,
etc. This also helps adjust the picture for
more natural colour.
How to Operate the Remote Control Transmitter
Inserting Batteries
einsert
two
batteries
as
illustrated
and
replace the cover. For models RM-AV2S
and RM-AV3S
use two "AA" or "UM-3"
1.5V batteries. For model RM-AV1S use two
"AAA" or "UM-4" 1.5V batteries.
Notes:
1. The infrared transmitter requires 3 volts
for operation. If the transmitter operating
power
is insufficient,
replace the bat-
teries.
. Position the positive and negative sides of
the batteries properly. Use of batteries
other than those specified may make the
remote control transmitter inoperative.
Advertisement
