Table of Contents
Advertisement
en
ENGLISH
Instructions on charging the battery pack can be
found in the operating instructions of the Metabo
charger.
7.3
Removing and inserting the battery pack
Fig. C
7.4
Setting the direction of rotation,
engaging the transporting safety device
(switch-on lock)
7.5
Select the gear
Do not set the gear switch (4) unless the motor
has stopped completely!
7.6
Set drill, thread tapping
Activate slide switch (3).
Note: To screw the sliding switch (3) select the
"Drill" position.
7.7
Setting torque control, maximum torque,
pulse function
Do not work for long periods with pulse
function switched on! (The motor can
overheat.)
Fig. F
Set the desired operating mode at the setting wheel
(13):
=
Pulse function
1...10 =
Torque control
=
maximum torque
Note: Pulse function is only available when sliding
switch (3) is set to "Drill".
7.8
Switching On/Off, setting the speed
Fig. A
Switching on, speed: press the trigger switch (15).
Press in the trigger switch to increase the
rotational speed.
Switching off: release the trigger switch (15). Note:
the noise that the machine makes when it
switches off is due to the design (quick stop)
and has no influence on the function or the
service life of the machine.
7.9
Keyless chuck
With a soft tool shank, retightening may be required
after a short drilling period.
Cleaning: from time to time, hold the machine
vertically with the chuck facing downwards and
turn the sleeve fully in the direction "GRIP, ZU"
and then turn fully in the direction
"AUF, RELEASE". The dust collected falls from
the keyless chuck.
7.10 Threadcutting
Only use machine tappers, which fulfil the
following conditions:
- Only use undamaged and sharp machine taps.
14
Fig. D
Fig. E
Fig. A
Fig. G
Fig. H
- Only use machine taps for right-hand threads.
Preparations:
- Make a hole (with a diameter that fits the tap
used).
- Set the gear switch (4) to Gear "1".
- Move the sliding switch (3) to "Thread
tapping"
- Adjust setting wheel (13) (see fig. below):
The appropriate setting depends on many factors,
in principle the following applies:
a) Blind holes and small through holes:
For blind holes, do not select too much torque so
that the tap does not snap when it reaches the
bottom of the hole. The Pulse
sponds to the smallest torque and the smallest
speed. Both values increase up to position 4.
b) Through holes:
Select a larger torque. From position 4 the speed
remains the same and only the torque increases.
For "Maximum torque" select position
1...10
a
4
3
2
1
- Attach the chuck matching the tap
(chuck "M8-12"/"M 4-6")
- Open the chuck.
- Insert tap.
- Insert taps of sizes M8 - M12, to the stop in the
chuck "M8-12" so that the square is held by the
holder inside the chuck.
- Insert taps of sizes M4 - M6, to the stop in the
chuck "M4-6" so that the square is held by the
holder inside the chuck.
- Close chuck and clamp tight.
- Lubricate hole and tap with appropriate cutting
oil.
Tappingthread
- Place tap on the hole.
- Move machine in axial direction.
- Depress the trigger switch (15) and at a low speed
and with moderate pressure, let the tap cut into the
hole. The speed can be increased during the
thread tapping.
position corre-
12
...
b
5
6
7
8
9
10
.
Nm
Advertisement
Table of Contents
