Table of Contents
Advertisement
SoftAP
(Depending on model)
• SoftAP is similar to Access Point. When this value is On, Wi-Fi Service application is displayed at the launcher bar. SoftAP is activated when user
selects On in the Wi-Fi Service application.
• Regardless of the Instant On mode, the SoftAP setting stays unchanged after power off/on. (Depending on model)
Use Default
• If you want to use default password(this password was generated randomly), you must select 'Enable' in this item.
Security Key
• If you want to change default password, you need to change 'Use Default' value into 'Disable' .
Wi-Fi Signal Strength
• You can control wireless signal strength on SoftAP. This is controlled by 5 step. If you select 'Not Used' , wireless signal strength will be set to Max
value.
Wi-Fi Channel
• You can control wireless channel on SoftAP mode. This is controlled from 1 to 11 channel. If you select 'Auto' , wireless channel of SoftAP will be set
to random channel.
Mode
(Depending on model)
• You can select NAT(Network address translation) mode and BRIDGE mode for Soft AP.
Security Type
(Depending on model)
• Type of security authentication protocol required for wireless connectivity
Radius Server IP, Radius Server Port, Radius Server Key
(Depending on model)
• If you want to use 802.1X, you must enter the IP address of the authentication server that manages the user's credentials, as well as the Port and
Key information.
VLAN ID
(Depending on model)
• SoftAP VLAN ID is needed when you want to separate TV packets and SoftAP packets.
• The packets via SoftAP are tagged when the packets go through LAN port to external network.
• It is not compatible with Network
46
VLAN ID. (SoftAP VLAN is not available if LAN port or AUX port in VLAN ID is set.)
Advertisement
Table of Contents
