Table of Contents
Advertisement
» Type of Connector: D-Sub 9-Pin Male
No.
1
2
3
4
5
6, 8
7
9
One Channel Map
(Depending on model)
• If set to 'Enable' , the TV will operate as below.
- A. When the TV is auto-scanning, it searches both air and cable channels.
- B. User can assign a channel number him/herself by manual scan.
- C. In 'Channel Edit' window, all channels are shown in a single list regardless of input source.
- D. Automatically scanned channels may not have the user-desired channel numbers.
• If user change the 'Enable/Disable' value, an pop-up window will be displayed to warn that all channel will be deleted. The Default value is
'Enable' .
DTV Channel Update
• It is a mode to set whether to update DTV Channel automatically or not.
• When set to 'Auto' , update Channel map according to DTV Channel's stream information.
• When set to 'Manual' , keep Channel map even though DTV Channel's information is changed.
32
Male connector on box, viewed towards connector.
Signal
VCC
RX RS232
TX RS232
IR from TV
GND
Not connected
2 A
1.5 A
Signal requirements
Standard RS232 specification
Standard RS232 specification
Power ground
+5 V DC 10 %, max 100 mV ripple
+12 V DC 10 %, max 100 mV ripple
Advertisement
Table of Contents
