Table of Contents
Advertisement
38
of the following dimensions:
Width:
591mm
- 594mm
Thickness:
16mm
- 24mm
Height:
depending on:
- recess height
- plinth height
- matchup to the joint runs of adjacent furniture (e.g. drawer), though
max. 600 mm
important Note! Should the furniture panel be longer than 600 mm, the appli-
ance door cannot be fully opened (the furniture panel bumps against the plinth).
In this case the plinth must be cut out (see installation template) or overlength
door hinge kit BLT 60 used. You can obtain this under E-No. 911239008.
Build-under (U models) and Build-In (E models) Appliances
For installation see installation instructions provided.
Freestanding Appliances
(1) Freestanding appliances do not need to be secured to adjacent furniture.
Note: (only applicable to freestanding appliances fitted with original worktop).
lf the dishwasher needs to be installed directly next to a heat source such as a
cooker or water heater, an insulation plate must be positioned to protect the side
of the worktop (depth 57.5 cm). The insulation plate should have aluminium foil
on the heat source side.
The original worktop of freestanding appliances has a front-to-back adjustment
of approx. 2 cm. This allows the worktop to be adjusted to match adjacent appli-
ances or furniture. To do this, proceed as follows:
(Unscrew and remove both screws that holds the worktop in place. These are
at the rear of the appliance.
OJ Move worktop backwards or forwards as required.
(Replace and tighten both screws.
Under Worktop Installation of Freestanding Machines
(J Freestanding machines can be built under a work surface if the machine's
original worktop has been removed.
AUF.3>
GB/UK
Advertisement
Table of Contents
