Table of Contents
Advertisement
SPE-10
GB/UK
Setting the wash programme:
[J Check that you have arranged the crockery and cutlery in your dishwasher
so that the spray arms are not obstructed.
(J Close the door
J Open the water tap fully, if closed
important! if a wash programme has started, though the water tap is closed
(WATER indicated), switch off the machine. Open the water tap and re-set the
wash programme.
Setting the Programme:
CJ Press ON/OFF button. All button indicators illuminate on the control panel.
(J Press the programme for the desired programme. (See "Progamme Guide")
The programme indicator lights up. All stages of the selected wash programme
are illuminated on the programme progress display. The multidisplay shows
the running time of the selected programme. During the programme the re-
maining running time is continuously displayed, (e.g. 1.20 = one hour plus 20
minutes to the end of programme). Six seconds after the last press of the
button, the programme starts. The programme progress indicator shows the
current wash stage.
Programme running time:
A wash programme can last varying lengths of time. The running time of a pro-
gramme depends on several factors. Examples are - temperature of incoming
water, amount of dishes, etc.
During the programme the machine's sensors continuously monitor these fac-
tors and shorten or lengthen the running time accordingly.
The actual running time required is memorised. At the next wash, using the same
programme, this stored running time is shown by the multidisplay at the begin-
ning of the programme.
While the programme runs, the sensors monitor the factors again and running
time is adjusted accordingly. In this way, the machine adapts itself to the indi-
vidual needs of your household.
Programme Correction:
You Can correct a wrongly selected programme if you press another programme
button within six seconds. After that time, a wash programme already started
can then only be corrected by cancelling the old and selecting a new programme.
(J Press ON/OFF button. All illuminated displays on the control panel go out. The
existing programme is cancelled.
Advertisement
Table of Contents
