Pioneer PL-560 Service Manual page 5

Bottom View
Cam assembly
PYY-164
A\ Power supply assembly
PWR-080
PU Cord assembly
PXB-345
Sub-panel assembly
%& *& Motor assembly
PY Y-163
%& & Start lever unit
PXV-036
%& & Slide switch
PSH-013
E-V angle
PNC-361
@® Mechanism Assembly and Motor ® Tone Arm
1. Turn on the turntable and free the mechanism. 1. Remove the mechanism assembly from the
. Fasten the tone arm to the arm rest. panel.
. Remove the rubber sheet and turntable. . Using a soldering iron, disconnect the PU lead
. Close the player hood and turn the player up- wires (arm lead wires) from the PU P.C. board.
side down and place it on a soft cloth so that . Remove the PU plate assembly AS spring.
the player hood is not damaged. . Remove the one screw © _ , and remove the
5. Remove the eleven screws (@ , and remove PU plate assembly from the tone arm.
the under base. . Remove the R clip.
6. Remove five screws @ and two screw © . .Turn the player onto its side, remove the
7. Disconnect connectors © . arm reset clamp, and remove the tone arm
The mechanism assembly can be removed from from the panel.
the panel.
8. Remove the two screws @ , and remove the
motor.
® CoD
He © bo
& or
® Power Supply Assembly
Remove the twoscrews © .
See pages 21 to 24 for the parts installation
and assembly precautions.
or
PL-560
Dust cover
Power supply
Turntable sheet assembly
assembly
Turntable platter
aa pu cord
assembly
PU plate
assembly