Pioneer PL-560 Service Manual page 19

11.2 PRECAUTIONS FOR ATTACHMENT OF
PARTS AND REASSEMBLY
e Reset Plate SP Attachment
As shown in Fig. 11-9, the reset plate SP hook is
attached by putting the open section on the sub-
panel base side.
Sub-panel
Reset plate SP
Selector
Fig. 11-9 Reset plate SP attachment
e Cam Assembly Attachment
The cam assembly is attached by letting the
lock plate go in the direction © as shown in Fig.
11-10.
Driving plate
Lock plate
Sub-pane! base
Fig. 11-10 Cam assembly attachment
PL-560
e Motor Attachment
When installing the motor, set the cam in the
mechanism stop location and verify that the
starting plate section @ does not protrude be-
yond surface @ of the cam. If the motor is at-
tached with the starting plate section ® protrud-
ing, the starting plate may be deformed, the motor
pinion gear may be scratched, and the returm
function may be damaged.
Fig. 11-11 Motor attachment
e Start Lever Unit Attachment
Attach the shaft section of the start lever unit
as shown in Fig. 11-12 so that it comes between
the reset plate and start plate.
Reset plate SP
Driving plate
ass'y
Fig. 11-12 Start lever unit attachment
23