Pioneer PL-560 Service Manual page 17

PL-560
11. PRECAUTIONS FOR REASSEMBLY
Follow these directions and precautions when
reassembling a unit after completing repairs. Be
sure to lubricate as required, make no mistakes
when attaching parts, and avoid all other careless
mistakes that may be the cause of trouble later on.
11.1 AREAS THAT REQUIRE LUBRICATION
NOTE:
Types of lubricants and areas where they are used are
listed in table 1.
Table 1
Type of Oil
Silicon Oil #50000
GYA-008
Areas used
raising shaft
all other areas
Lubrication points are specified for oils other
than GYA-008. Never use a different type of oil.
® Cam Section
Apply grease to the heart-shaped grooved section
(rear side of the cam) and lock plate sliding section
in order to minimize wear on the sliding section
and the burden on the mechanism.
e Driving Plate Assembly
Decrease the burden on the mechanism and the
wear on the sliding section.
Sides surface :
(Sliding section of ™
auto-stop mechanism)
Top and side
(Sliding section of
auto-stop mechanism)
EV cam notched Part
(PU plate pin sliding section)
@ Switch Locker Section
Apply grease to the switch locker (opening) and
sub-panel base sliding section to decrease the
burden on the mechanism.
When applying grease to the opening (shaft hole),
do not apply any grease 2 ~ 3mm from the bottom
surface. If grease is applied 2~3mm within the
bottom surface, it may come out the bottom and
go between the switch lever and sub-panel base
causing the switch lever to operate ineffectively.
Switch locker
Fig. 11-2 Switch locker section
e Selector Section
Apply grease to the surface of the sub-panel base
of the selector sliding section to decrease the
burden on the mechanism and wear on the sliding
section.
Side surface
Sub-panel
KR
surface
Side surfaces
Fig. 11-3 Selector section
e Reset Plate Section
Apply grease to the sub-panel base (shaft) and
sliding section of the reset plate to decrease the
burden on the mechanism.
Reset plate
Sub-panel base
Apply grease (GY A-008)
to shaft section
Fig. 11-4 Reset plate section
a1