C Installing Parts Shipped Loose-Cutting Board; D Installing Parts Shipped Loose-Compressor Filter - Traulsen TRP Series Owner's Manual

3. INSTALLATION (continued)
3C - INSTALLING PARTS SHIPPED LOOSE: CUTTING BOARD
Place cutting board so that the holes in the cutting board line up with the pins on the counter top (See Fig. 2).
Fig. 2
3D - INSTALLING PARTS SHIPPED LOOSE: COMPRESSOR FILTER
Remove louvered panel by lifting up and pulling out entire panel. Slide the filter into the tracks located below the compressor
compartment. Be careful not to catch the filter on sharp edges when installing. Replace louvered panel by installing top of
panel into track and pushing in the bottom so that the locking clips fit inside the opening (See Fig. 3).
Fig. 3
TRP SERIES
Page 4