IBM 9009-41A Manual page 44

Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
a. Release the service cover latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover clears the upper
frame ledge, lift the cover up and off the system unit.
Figure 24. Removing the service access cover from a rack-mounted system
For a stand-alone system, complete the following steps. Refer to Figure 25 on page 31.
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
a. Release the latch by pushing the release latch (A) in the direction shown.
b. Slide the cover (B) off the system unit. When the front of the service access cover has cleared the
upper frame ledge, lift the cover up and off the system unit.
30 Power Systems: NVMe M.2 carrier cards and flash modules for the 9009-41A, 9009-42A, or 9223-42H