Answering System Operation; Setting The Day/Time Stamp; Recording Your Outgoing Messages - BellSouth GH5860 Owner's Manual

5860 man.qxd
Operation
11/7/2003 5:48 PM

Answering System Operation

IMPORTANT: To ensure the proper operation of your Answering System:
1. Plug the AC ADAPTOR into the POWER - IN CONNECTION Jack.
2. Press and hold down the RESET button for 2 seconds at the back of the BASE
UNIT before initial use.

Setting the Day/Time Stamp

vol+
vol-
play
ogm
time
code
m2 m3
NOTES:
1. The HANDSET and BASE UNIT clocks are independent from each other. Set the
HANDSET clock by following the time setting steps on page 23.
2. In case of power failure, reset the time setting on the BASE UNIT clock.

Recording Your Outgoing Messages

Your Answering System provides one PRIMARY MAILBOX and four individual MAILBOXES
(1, 2, 3, 4) which can receive their own Incoming Messages (ICM). Before using your Answering
System, it is suggested that you record an Outgoing Message (OGM). This is the announcement
callers will hear when the system answers a call.
A prerecorded system announcement "Please record your message after the beep" is available
if you choose not to record your own OGM.
Page 39
1. Day Setting
Press and hold down the
seconds then press the
erase
to select the desired day setting. Press the
stop
button again to accept the setting, and
time
then the LED Screen will display the hour
setting.
2. Hour Setting
Press the
hour, then press the
setting. The LED Screen will display the
minute setting.
3. Minute Setting
Press the
desired minute, then press the
accept the setting.
30
button for 2
time
or button
or button to select the
button to accept the
time
or button to select the
button to
time