Chauvet COLORdash Par Hex 7 Quick Reference Manual page 3

COLORdash™ Par-Hex 7 QRG
AC Power
Power Linking
AC Plug
Replacing The Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
All manuals and user guides at all-guides.com
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
You can link up to 27 COLORdash™ Par-Hex 7 products at 120 V, 46 products at
208 V, or 52 products at 230 V. Never exceed this number. Power linking cords
can be purchased separately.
Connection Wire (U.S.)
AC Live
AC Neutral
AC Ground Green/Yellow
1. Disconnect this product from power.
2. Using a flathead screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The COLORdash™ Par-Hex 7 will work with a DMX controller using a
3- or 5-pin DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The COLORdash™ Par-Hex 7 uses a 3- or 5-pin DMX data connection for its
DMX personalities: 6 Ch, 8 Ch, 12Ch, 13Ch, HSI, and HSV. See the User
Manual for information about connecting and configuring the product for DMX
operation.
Note: For optimum control of the 16-bit dimming channels in the 13Ch
personality, be sure that Dim mode is set to Off.
The COLORdash™ Par-Hex 7 uses the DMX data connection for its Master/Slave
mode. See the User Manual for information about connect and configure the
product for master/slave operation.
Wire (Europe)
Black Brown
White Blue
Green/Yellow
3
EN
Screw Color
Yellow/Brass
Silver
Green