AT&T 610 User Manual page 67

User's Guide
August 1985
Character Sets
Two character sets are active at any given time. They are
named GO and Gl. At power up, both are set to the United States
charac ter se t. GO is assigned one of the following character
sets when the sequence ESC( character (refer to Section 6 and 7)
is received; Gl is assigned one of the following character sets
when the sequence ESC) character (refer to Section 6 and 7) is
received:
• United Kingdom Character Set
• United States Character Set
• Special Character and Line Drawing Character Set
• Securities Industry Character Set
• Mosaic Character Set
At power up, character set GO is active. Upon receipt of
the SO (Shift Out) character (Control N), character set Gl
bec.omes ac tive. Receiving SI (Shift In) character (Control 0)
causes GO to become the active character set again. Regardless
of the active character set, the United States character set
is
always used on the status line and when in SETUP.
Downloading
Options and Fkeys can be downloaded to the terminal. Each
of these downloads is done through the use of escape sequences
which are described in the following paragraphs.
SettiDg Options On-Line
Options may be downloaded to the terminal by using the
following escape sequences (ESC
is
the ESCAPE character):
Option
*SPEED SELECTION (Baud)
110
Baud, 11 Unit Code
/
300
Baud,
10
Unit Code
1200
Baud,
10
Unit Code
2400
Baud,
10
Unit Code
4800
Baud, 10 Unit Code
9600
Baud,
10
Unit Code
19200
Baud, 10 Unit Code
Sequence
ESC[1;5 :
ESC
[1
;61
ESC[l;O:
ESC[1;1:
ESC [1 ;21
ESC [1;3:
ESC [1;4:
Operations
Page 6- 5