AT&T 610 User Manual page 16

Unpack and Install
Page 1- 2
Caution:
To avoid condensation on the electronic
components, the components should be allowed
to assume room temperature before unpacking.
This is especially important when the boxes
are brought into a warm humid room from
outside subzero temperature.
User .... s Guide
August 1985
1. Open the top of the controller/base (55C710AAAA (PE Code
3344-610» box by removing or cutting the tape. The User's
Guide (999-300-2701S) and the Pocket Reference
(999-301-2701S) are in the carton with the controller/
base. Remove the controller/base from the carton and place
i t at the location where the terminal is to be installed.
2. Refer to codes listed below for proper phosphor color of
the monitor.
• 53D210AAA -- White (PE Code 33410-COL10)
• 53D210YAA
Amber (PE Code 33410-COL19)
• 53D210ZAA
Green (PE Code 33410-COL01)
Position carton in accordance with instructions on the
outside of the carton indicating which side should be up.
Open the top of the monitor carton by removing or cutting
tape. Remove the monitor and assemble to swivel mechanism.
on the controller/base by following the steps given below.
a. Remove unpacking and installation instructions from
carton. Retain for possible future reference.
b. Fold flaps of carton back and turn carton upside-down
being careful to keep the monitor from sliding out of
box while it is being turned over.
c. Slide carton up and discard.
d. Lift iutonitor with styrofoam pack and place next to
controller /base. Orient the monitor with the screen
downward and the bottom facing towards the inst'aller
(see Figure 1-2).
e. Spread opening of plastic bag (not shown) covering
monitor so that four rectangular cutouts are clear.
f. Pick up controller/base and align tabs on swivel to
lower cutouts on bottom of monitor.