Table of Contents
Advertisement
Installation
Modular box lubricators are not approved for use
in hazardous locations or explosive atmospheres
unless all accessories, components and wiring
meet all local and national codes.
Component Identification
ti17757
G
A
F
. 1
IG
Key:
A
Site glass
B
Fill cap
C
Drain plug
D
Pump blank
E
Drive shaft - (with woodruff key)
F
Mounting holes
G
Accessory plug (heater port)
H
Pump (not on all models)*
J
Mounting screw
*The GBL7500 Box Lubricator Pump and GBL Shaft Rota-
tion/Low Level Alarm Pump are available from Graco. See
Accessories/Other Accessories, page 12 for information about
these pump models and the related instruction manual.
3A2100K
D
H
J
B
C
F
E
Grounding
The equipment must be grounded to reduce the risk
of static sparking. Static sparking can cause fumes
to ignite or explode. Grounding provides an escape
wire for the electric current.
a
b
F
. 2
IG
1. Loosen grounding screw (a) (F
end of a 12 gauge (1.5mm) minimum ground wire
between the grounding screw and washer (b).
2. Tighten grounding screw (a) securely.
3. Connect other end of wire to a true earth ground.
Installation Procedure
Reference letters used in the following instructions,
refer to F
. 1.
IG
1. Select a mounting surface that satisfies the follow-
ing:
•
Is able to support the weight of the reservoir
and fluid when filled to capacity.
NOTE: When possible, mount to a surface that
experiences little or no vibration.
•
Allows easy access to the lubricator for filling
the reservoir and periodic maintenance.
•
The lubricator must be connected to a ground
source.
2. Install reservoir to the mounting surface. See
mounting hole layout in the Reservoir and Mounting
Dimension section of this manual, page 14.
3. Install bolts through holes (F) in reservoir mounting
bracket and tighten securely.
Installation
. 2) and place one
IG
5
Advertisement
Table of Contents
