Reset Menu; Reset All Memories; Refresh Mode; Light Source Calibration - Epson EB-PU1008 User Manual

Reset Menu

Settings on the Reset menu let you reset certain projector settings to their
default values.
g g Related Links
• "Reset All Memories" p.113
• "Refresh Mode" p.113
• "Light Source Calibration" p.113
• "NFC Settings" p.114
• "Reset All Config" p.114
• "Reset All (Factory Default)" p.114

Reset All Memories

Reset > Reset All Memories
s
You can delete all memories saved in Memory, Lens Position, and Geometry
Correction.

Refresh Mode

Reset > Refresh Mode
s
The refresh mode process clears any projected afterimage and turns off the
projector after a specified period of time.
Timer
Set a time period during which the projector displays the refresh image.
Messages
Set to On to display a message informing you that the projector is in
refresh mode.
Start
Starts the refresh mode process to clear any projected afterimage and turn
off the projector after a specified period of time. Press any button on the
remote control to cancel this process.

Light Source Calibration

Reset > Light Source Calibration
s
The light source calibration process optimizes the color balance of the
currently projected image.
Run Now
Starts light source calibration to optimize the color balance of the currently
projected image. You may not be able to start calibration if the projector's
environmental temperature is out of range. (Wait 30 minutes after turning
on the projector before starting calibration for the best results.)
Light Source Calibration does not start in the following cases.
• If the projector is not used continuously for more than 20 minutes.
• If the surrounding temperature gets too high, and the brightness has
been automatically dimmed.
• If you use the following functions and the brightness of the light source
declines to a specific level or lower.
• Dynamic Contrast
• Lights-Out Control
• A/V Mute
• Within 10 minutes of turning on the projector.
• If Brightness Settings is set to 30% or less.
Run Periodically
Set to On to perform light source calibration periodically every 100 hours
of usage.
When set to Off to maintain the projected image that has been adjusted
using Multi-Projection, perform calibration using Run Now or set a Light
Source Calibration event to perform it periodically on the Schedule
Settings screen.
Schedule Settings
Displays the Schedule Settings screen. Set a Light Source Calibration
event to run periodically.
Last Run
Displays the date and time of the last light source calibration.
113