Kenwood TR-851A Instruction Manual page 12

49) COM (Common channel) switch (With
the TR-851A/751A)
The COM switch selects the COM channel {common
frequency) by the use of a single keystroke operation.
The frequency has been factory-set to 433.00 MHz
with the TR-851A and 145.00 MHz with the
TR-751A, but may be reset to any desired frequency.
TONE switch (With the TR-851E/751E)
This switch activates the
{1,750 Hz) circuit.
repeater control tone
20; LOW switch
Press this switch to select low power transmit out-
put; press it again to restore high power transmit
output.
When this switch is pressed, the transmit output
levels change as follows:
HIGH: 25W
LOW: approx. SW
2) RIT switch
Press this switch to enable RIT; press it again to
disable RIT.
Set the RIT switch to ON; the RIT indicator lights. Turn
the RIT knob to vary the receive frequency.
If you press the RIT switch in the FM mode, a series of
beeps will sound indicating the RIT feature is not
enabled.
i
. Display panel
F.STEP display:
AL display:
VFO display:
MR display:
OFFSET display:
Tone display:
LOCK display:
REV display:
CHL display:
C.SQ display:
Channel display:
Stand by indicator:
50 Hz display:
kHz dot:
Frequency display:
MHz dot:
RIT display:
14 1312 10 10 9
ON when the F.STEP is ON.
ON when using AL.
ON when VFO A or VFO B is
selected.
ON when MR is. selected
(Memory channel operation).
ON when shift is set to' +°'
or =" ("D-A' or 'D-B"
with the TR-851E European
version) using the OFFSET
key.
ON when TONE is selected.
ON when F.LOCK has been
selected.
ON when using the REV
function.
Flashes during open channel
search by CHL key. ON after
channel linkage.
ON when using C.SQ (Code
squelch).
Normally displays memory
channel; displays code chan-
nel during digital code
display.
Specifies which codes will
be actively used.
ON when the second digit is
5; OFF when it is O.
ON when 50Hz step is
selected; flashes during scan.
Frequency, tone frequency,
digital code, and call sign.
Flashes during scan.
ON when using RIT.