Toro 74943 Operator's Manual page 66

Riding mower with 48in, 52in, 60in, or 72in turbo force mower
Hide thumbs Also See for 74943:
Table of Contents

Advertisement

Replacing the Hydraulic Fluid and
Filters
Service Interval: After the first 250 hours—Change
the hydraulic filters and hydraulic
fluid when using any type of fluid.
Every 250 hours—Change the hydraulic filters
and hydraulic fluid when using Mobil
(more often in dirty or dusty conditions).
Every 500 hours—Change the hydraulic
filters and hydraulic fluid when using Toro
HYPR-OIL
500 hydraulic fluid (more often in
dirty or dusty conditions).
To replace the hydraulic fluid, the filters need to be
removed. Replace both at the same time; refer to
Hydraulic-Fluid Specifications (page 65)
specifications.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Raise the machine and support it with jack
stands
(Figure
102).
Figure 102
1. Jack stands
4.
Remove both the mower belt and the pump-drive
belt; refer to
Replacing the Mower Belt for
Side-Discharge Mower Decks (page 59)
Replacing the Mower Belt for Rear-Discharge
Mower Decks (page
the Hydraulic Pump-Drive Belt (page
Note:
This prevents oil from getting on the
belts.
®
1 fluid
®
for the oil
or
60), and refer to
Replacing
61).
5.
Place a drain pan under the filter, remove the old
filter, and wipe the surface clean
Bottom view of the machine
1. Filter locations
6.
Apply a thin coat of hydraulic fluid to the rubber
gasket on the replacement filter
7.
Install the replacement hydraulic filter.
8.
Install the pump-drive belt and the mower belt.
9.
Remove the jack stands and lower the machine
(Figure
102).
10.
Add fluid to the hydraulic reservoir and check
for any leaks.
11.
Clean up any spilled fluid.
12.
Start the engine and let it run for about 2 minutes
to purge air from the system.
13.
Shut off the engine and check for leaks.
14.
Check the fluid level while the fluid is cold.
g008970
15.
If required, add fluid to the hydraulic reservoir.
Note:
Do not overfill.
66
(Figure
Figure 103
2. Hydraulic filter
(Figure
103).
g008968
103).

Advertisement

Table of Contents
loading

Table of Contents