Toro 74943 Operator's Manual page 40

Figure 49
Machine with Rear Discharge Shown
4. Grease the drive-belt idler arms
Figure 50
5. Grease the deck-belt idler arms (rear discharge
machines only) as shown in
g192516
(Figure 50).
g009030
Figure 51.
40
Figure 51
Machines with Rear Discharge Only
6. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
done.
7. Remove the hex plug.
8. Thread a grease fitting into the hole.
9. Pump grease into the fitting until it oozes out
around the top bearing.
10. Remove the grease fitting in the hole.
11. Install the hex plug and dust cap
Figure 52
12. Grease the caster-wheel bearings
g024207
(Figure 52).
g027339
(Figure 52).