Storage; Cleaning And Storage - Toro 74675 Operator's Manual

Storage

Cleaning and Storage

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Ensure that the parking brake is engaged, shut off the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine.
4. Clean dirt and chaff from the outside of the engine
cylinder-head fins and blower housing.
Important: You can wash the machine with a mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
5. Service the air cleaner; refer to
Cleaner (page 32).
6. Grease and oil the machine; refer to
31).
7. Change the crankcase oil and filter; refer to
the Engine Oil and Oil Filter (page
8. Check the tire pressure; refer to
Pressure (page 40).
9. Charge the battery; refer to
39).
10. Check the condition of the blades; refer to
the Blades (page 41).
11. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows.
12. Add a petroleum-based stabilizer/conditioner to
the fuel in the tank. Follow the mixing instructions
from the stabilizer manufacturer. Do not use an
alcohol-based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most effective
when mixed with fresh fuel and used at all times.
A. Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
B. Shut off the engine, allow it to cool, and drain
the fuel tank.
C. Start the engine and run it until it stops.
D. Choke the engine. Start and run the engine until it
does not start.
E. Dispose of fuel properly. Recycle pursuant to
local codes.
Important: Do not store stabilizer/conditioned
gasoline over 30 days.
Servicing the Air
Lubrication (page
Changing
34).
Checking the Tire
Charging the Battery (page
Inspecting
13. Remove the spark plug(s) and check its condition;
refer to Servicing the Spark Plug (page
spark plug(s) removed from the engine, pour 30 ml
(2 tablespoons) of engine oil into the spark plug hole.
Use the starter to crank the engine and distribute the
oil inside the cylinder. Install the spark plug(s). Do not
install the wire on the spark plug(s).
14. Clean any dirt and chaff from the top of the mower.
15. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
16. Check the condition of the drive and mower belts.
17. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is worn or damaged.
18. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
19. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
50
35). With the