Before Operation; Before Operation Safety - Toro 74675 Operator's Manual

Table of Contents

Advertisement

Key Choice
®
Switch
This switch allows you to mow in reverse when it is activated.
To activate it, turn the switch to the O
it after the PTO is engaged. To deactivate it, disengage the
power takeoff (PTO)
(Figure
Operating-in-Reverse Warning Light
The Operating-in-Reverse warning light illuminates
whenever you use the Key Choice key to deactivate the
operating-in-reverse interlock. It is a reminder that the
interlock system is deactivated. The light goes out whenever
you disengage the PTO or shut off the engine. When the light
is on, look behind you and use extra caution when backing up.
Smart Park
Switch
The parking brake is activated electronically.
Engage the parking brake by 1 of the following actions:
Pressing the Smart Park
(Figure
6).
The parking brake engages automatically when you leave
the seat and the traction control pedal is in the
position.
The parking brake automatically engages 5 to 6 seconds
after the ignition switch is turned to the
it is not already engaged).
To disengage the parking brake, press the Smart Park switch
to the
position with the key in the
OFF
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
position and release
N
7).
switch to the
position
ON
NEUTRAL
position (if
OFF
position.
RUN
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.

Before Operation

Before Operation Safety

General Safety
Never allow children or untrained people to operate or
service the machine. Local regulations may restrict the
age of the operator. The owner is responsible for training
all operators and mechanics.
Become familiar with the safe operation of the equipment,
operator controls, and safety signs.
Know how to stop the machine and shut off the engine
quickly.
Check that operator-presence controls, safety switches,
and shields are attached and functioning properly. Do not
operate the machine unless they are functioning properly.
Before mowing, always inspect the machine to ensure that
the blades, blade bolts, and cutting assemblies are in good
working condition. Replace worn or damaged blades and
bolts in sets to preserve balance.
Inspect the area where you will use the machine and
remove all objects that the machine could throw.
Evaluate the terrain to determine the appropriate
equipment and any attachments or accessories required to
operate the machine properly and safely.
Fuel Safety
To avoid personal injury or property damage, use extreme
care in handling fuel. Fuel vapors are flammable and
explosive.
Extinguish all cigarettes, cigars, pipes, and other sources
of ignition.
Use only an approved fuel container.
Do not remove the fuel cap or add fuel to the fuel tank
while the engine is running or while hot.
Do not refuel the machine indoors.
Do not store the machine or fuel container where there
is an open flame, spark, or pilot light, such as on a water
heater or on other appliances.
Do not fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers on
the ground, away from your vehicle before filling.
Remove the equipment from the truck or trailer and
refuel it while it is on the ground. If this is not possible,
then refuel from a portable container rather than a
fuel-dispenser nozzle.
14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter sw 5000Timecutter sw 420074680

Table of Contents