Removing The Rear Wheel - KTM 390 DUKE 2024 Owner's Manual

14 WHEELS, TIRES
14.3
78
T04601-02

Removing the rear wheel

–
Clean the thread of the wheel spindle and screw
–
Clean and grease wheel spindle.
Long-life grease ( p. 121)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, wheel spin-
dle, front
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel speed
sensor holder
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
( p. 66)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
5
Tighten screws .
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with the rear lifting gear. (
2
.
2
.
M24 45 Nm (33.2 lbf ft)
3
in the hole.
2
.
M6 8 Nm (5.9 lbf ft)
p. 67)
M8 15 Nm (11.1 lbf ft)
p. 66)