Samsung SC-D351 Owner's Instruction Book page 85

I ENGLISH I
USB Interface (SC-D352/D353/D354/D355 only)
Transferring a Digital Image through a USB Connection
÷ The camcorder supports both USB 1.1 and 2.0 standards. (Depends on the PC specification)
+ You can easily transfer a image from a Memory card to a PC without additional add-on cards via a USB connection.
+ You can transfer a recorded file in memory card to a PC via a USB connection. (SC-D353/D3541D355only)
÷ If you transfer data to a PC, you need to install the software (DV Driver,Video Oodec, DirectX 9.0) supplied with the
Camcorder.
USB Connection speed depending on the System
High speed USB connection is supported by Microsoft (Windows) device drivers only.
• Windows 98SE/ME - Full Speed USB
• Windows 2000 - High speed USB on a system with Service Pack 4 or later installed.
• Windows XP - High speed USB on a system with Service Pack 1 or later installed.
System Requirements
Windows System
-- --_ Minimum Recommended
CPD Intel ® Pentium III
TM,
600MHz InteP Pentium 4
TM
, 2GHz
OS(Operating System) Windows _ 98SE/ME Windows ®2000/XP
Memory 128MB 512MB
HDD capacity 1GB or more 2GB or more
Resolution 1024 x 768 dots 1024 x 768 dots
24bit Color 24bit Color
USB USBI.1 USB2.0 High Speed
It is not available for Macintosh systems.
Notes]
USB 2.0 works only for removable disk functions.
On a slower PC than recommended, movie playback may not be smooth or video editing may take a long time.
On a slower PC than recommended, movie playback may skip frames or operate unexpectedly.
Intel e Pentium Ill
TM
or Pentium 4
TM
is a trademark of the Intei Corporation.
Windows _ is a registered trademark of the Microsoft _ Corporation.
All other brands and names are property of their respective owners.
Operations are not guaranteed for all of the recommended computer environments mentioned above.
Do not connect the Camcorder to a PC using both DV and USBcables. It may not operate properly.
In M.Cam or M.Player mode, be sure that the Memory card is inserted into Camcorder before connecting USB cable.
If no Memory card or an unformatted Memory card is inserted, PC will not recognize your Camcorder as a removable disk.
(SC-D353/D354/D355 only)
i SB Streaming requires Video Codec, DV Driver and DirectX 9.0.
If you disconnect the USB cable from the PC or the Camcorder during the data transfer, the data transfer will stop and the data may be damaged.
If you connect the USB cable to a PC using a USB HUB or with other devices at the same time, it may cause conflict and may not work properly.
If this occurs, remove all other USB devices and try the connection again.