Table of Contents
Advertisement
Setting Up the Satellite Dish Antenna and Terrestrial Inputs
Terrestrial Antenna or Cable without
a Satellite Connection
If you connected a terrestrial antenna or local cable TV service to view local analog or digital
channels, you need to configure the DST-3000 receiver to receive these broadcasts.
Highlighting the Local Area button on the INSTALLATION screen and pressing the
on the remote control will display the LOCAL AREA screen. Using the
either the Local In 1 button if you connected your terrestrial antenna or cable service to the jack
labeled IN FROM ANT. Or, highlight the Local In 2 button if you connected your terrestrial
antenna to the jack labeled SATELLITE IN. Then press the
display the Local In pop-up menu.
On the Local In pop-up menu, use the
connection made to the DST-3000 receiver, and then press the
Local In Connection Options
The connection options found on the Local In 1 and Local In 2 pop-up menus are:
None
You are not connected to an antenna or cable.
Antenna
You have connected a standard VHF/UHF indoor or outdoor antenna.
Cable TV (STD) You have connected a cable service that uses a standard type of cable signal.
Cable TV (HRC) You have connected a cable service that uses the HRC type of cable signal.
Cable TV (IRC) You have connected a cable service that uses the IRC type of cable signal.
Note: Consult your cable company to find out what type of cable signal you have.
After selecting your Local In Type and pressing the
LOCAL AREA screen will be displayed.
Note: Local In 1 and Local In 2 must have different input signal types. The
receiver does not support the simultaneous connection of two terrestrial
antenna signals or two cable signals.
Selecting the Correct Satellite Dish Type for Terrestrial-only
Operation
If you have a terrestrial-only antenna hookup (that is, no satellite dish), you must configure the
DST-3000 receiver for a DISH TYPE of "None" so it will not search for a satellite signal.
Highlighting the Dish Setup button on the INSTALLATION screen and pressing the
on the remote control will display the DISH SETUP screen.
Highlighting the Dish Type button on the DISH SETUP screen and pressing the
the remote control will display the DISH TYPE pop-up menu. Using the
dish type "None" and press the
L
and
L
keys to highlight the buttons for the type of
SELECT
key.
SELECT
L
and
L
keys, highlight
key on the remote control to
SELECT
key on the remote control.
SELECT
key on the remote control, the
SELECT
L
and
L
keys, highlight
key
SELECT
key
SELECT
key on
Page 4-9
Advertisement
Table of Contents
