Hd Receiver And Hdtv Monitor - Toshiba DST-3000 Owner's Manual

Note: Signals from a terrestrial antenna and cable TV can be connected to the
IN FROM ANT connector and diplexed into the SATELLITE IN connection
simultaneously. However, the receiver does not support the simultaneous
connection of two terrestrial antenna signals or two cable signals.
Note: In order for the Advanced Program Guide™ to receive the correct
listing of local channels and local program information from DIRECTV, make
sure you select the correct zip code or cable provider on the LOCAL
PROVIDERS screen. Refer to Chapter 4, "Setting Up the Satellite Dish
Antenna and Terrestrial Inputs."

HD Receiver and HDTV Monitor

Follow these steps indicated by the diagram on the next page:
1) Connect the satellite dish antenna and terrestrial antenna or cable service to the HD
receiver following instructions in "HD receiver and Satellite Dish Antenna with Terres-
trial Antenna or Cable Service" on page 2–3.
2) Connect one set of Component Video Cables (one green Y connector, one red P
tor, and one blue P
marked Y, P , and P
r
monitor using the HDTV input connections marked Y, P
Note: Connect the Y, P
P , and P
r
1080i scanning rate and that comply with the EIA 770.3 signal standards.
Refer to your television owner's guide for verification.
3) Connect one set of audio cables (one white left audio connector and one red right audio
connector) to the back of the HD receiver using the connectors marked AUDIO L, R.
Connect the other end of the audio cables to the back of the HDTV monitor using the
audio inputs.
Note: This connection allows the use of the speakers in the TV to hear the
sound.
4) Optional: Connect one set of audio cables and a video or S-video cable to the back of the
HD receiver using the connectors marked AUDIO L, R and VIDEO or S-VIDEO.
Connect the other end of audio and video cables to the back of the HD monitor using the
AUDIO and VIDEO or S-VIDEO inputs.
Note: This connection allows you to send standard 480i signals to your TV.
For better standard definition performance, if your TV has an S-VIDEO connector, then
use an S-video cable instead of the yellow video cable.
Note: When the HD receiver is converting all signals to standard 480i signals
that can be viewed on standard video inputs of TVs, there will be no signals on
the Y, P
r
1080i format that can be sent to the HDTV input of HD monitors, there will be
no standard 480i signals to standard video inputs of TVs.
Page 2-4
Toshiba DST-3000 High Definition Digital Receiver
connector) to the back of the HD receiver using the connections
b
. Connect the other ends of this cable to the back of the HDTV
b
, and P
r b
connectors on your TV that are compatible with HD signals in the
b
, and P connectors. When the HD receiver is converting all signals to
b
, and P .
r b
connectors of the HD receiver only to the Y,
connec-
r