Yamaha MT-10 SP 2016 Owner's Manual page 80

Periodic maintenance and adjustment
1
2
3
4
5
1. Coolant reservoir cap
4. Add coolant to the maximum level
6
mark, and then install the reservoir
cap. NOTICE: If coolant is not
available, use distilled water or
7
soft tap water instead. Do not
use hard water or salt water
8
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
9
ant as soon as possible, other-
wise the cooling system will not
10
be protected against frost and
corrosion. If water has been
11
added to the coolant, have a
Yamaha dealer check the anti-
freeze content of the coolant as
12
soon as possible, otherwise the
effectiveness of the coolant will
be reduced.
Coolant reservoir capacity (up to the
1
maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
To change the coolant
1. Place the vehicle on a level sur-
face and let the engine cool if nec-
essary.
2. Place a container under the engine
to collect the used coolant.
3. Remove the radiator cap retaining
bolt and radiator cap. WARNING!
Never attempt to remove the ra-
diator cap when the engine is
hot.
[EWA10382]
[ECA10473]
EAU73983
1. Radiator cap retaining bolt
2. Radiator cap
1. Coolant drain bolt
2. Gasket
7-14
1
4. Remove the coolant drain bolt and
its gasket to drain the cooling sys-
tem.
5. Remove the coolant reservoir cov-
2
2
1