Table of Contents
Advertisement
en Installation instructions
The gas pressure regulator supplied with the appli-
4.
ance must be installed in line with the gas pipe (NG
only). Pressure test point:
5.
To perform a leak test, see the section entitled
"Leak test". Open the gas supply.
Connection for Universal liquefied gas (ULPG)
With Universal liquefied gas (ULPG), the gas connec-
tion is made via a flexible gas tube or a fixed tube.
Important information for the use of a flexible gas
tube:
¡ A flexible security gas tube or a plastic tube with a
diameter of 8 or 10 mm must be used.
¡ It must be secured to the gas connection with a per-
missible connection device (e.g. hose clamp).
¡ It must be short and fully leakproof. The tube can
have a maximum length of 1.5 m. Observe current
requirements.
Caution!
¡ It must be replaced once a year.
¡ Observe the country-specific requirements.
23.6 Converting the gas type
You can convert the type of gas that has been set for
the appliance.
Note: You can find more information about which gas
types can be used with the appliance and the appropri-
ate gas nozzles in the section entitled "Technical data –
Gas" → Page 54. The numbers on the burners refer to
their diameter.
Converting the gas type
¡ Replacing the gas connection part.
¡ Replace the burner nozzles.
¡ Depending on the gas setting that is configured at
the factory, replace or tighten the bypass nozzles of
the burner taps.
After conversion
¡ Always test for leaks after converting the appliance
to a different gas type. You can find additional in-
formation about this in the section entitled "Leak
and function test" → Page 53.
¡ The burning behaviour must be checked after the
product has been converted to a different gas type.
You can find additional information about this in the
section entitled "Checking the correct burner beha-
viour" → Page 54.
¡ Enter the newly set type of gas and gas pressure in
the table. You can find additional information about
this in the section entitled "Appliance information"
→ Page 48.
50
ATTENTION!
After converting the type of gas, label the type of gas
that is now set.
After converting the type of gas, affix the label with
▶
the specification of the gas type and the star shape
at the designated location on the appliance's rating
plate.
Functional parts for the gas conversion
The functional parts that are required for the gas con-
version in accordance with the instructions are dis-
played below.
Note:
(*) These functional parts must be used when the gas
is connected.
¡ The gas connecting piece to be used may vary de-
pending on the gas type and country-specific regu-
lations.
¡ You will find the correct nozzle diameters in the
table in the section entitled "Technical properties -
gas".
¡ Always use new seals.
Replacing the cooker burner nozzles
Switch off all of the knobs on the control panel.
1.
Close the gas connection shut-off.
2.
Remove the pan support grids or the pan support
3.
racks and the burner parts.
Açıklama
Bypass screw
Burner nozzle
(*) Seal
(*) Connecting piece for nat-
ural gas
(ISO 7-1)
(*) Connecting piece for nat-
ural gas
(NG: G20)
Gas Pressure Regulator
Gas connecting piece
Dummy plug (shut-off piece)
Advertisement
Table of Contents
