Harman Kardon AVR30 Owner's Manual page 7

harman/kardon AVRA30 Audio and Video Receiver
fe] oe ;
A-8B
TS eee
Speaker Bass Treble
Headphones
Ue
General Information
Placement:
Unit may be placed on top of or
beneath other stereo components,
so long as Its placement meets the
cooling requirements of the
component beneath it.
AC Power
Plug the cord into a polarized wail
socket, or polarized extension cord.
7 2 3 4
D @ a Cp g
5 6 7 8
Audio Direct Surround Mode - Effects Level + Center Mode Delay Time Test Tone
Remote Sensor
FM f
SEEK TUNED stereo Preset EEE
aaa
Balance Subwoofer Leve/ Center Level Rear Level
Of AB @ ° e e e@ e
Cy" * C ) C ) C ) ( ) =
-@ et -@ et Le ef Min @ @ Max Min @ @ Max Min @ @ Max
Simulcast] VCR 1 | VCR 2 | VDP VoP SAT TV
a U U O O 0 Q
AC Outlets (120 Volt
Version Only)
2 SWITCHED OUTLETS and 1
UNSWITCHED OUTLET
Use these to connect the power cords
from your components to this unit.
The power to the SWITCHED outlets
is controlled by this unit's POWER
switch or the provided remote-control
transmitters POWER key. These
outlets will supply power to any
MHz zest pinecr [ ciue | ,_ EFFECTS LEVEL
ae G7 C+ Kee [ero ooe linear) chet
[MALL } [Wide] [Nona] [PHaNTOn)
S bh gow
Listen to] Tape 7 Tape 2 Aux cD Tuner Phono | Loudness
Q U 0 0 Q U
Ree from
pe fo]
a
aT
D q
(aso
Master Volume
EFF
component whenever this unit is
turned on.
The power to the UNSWITCHED
outlet can not be controlled by
this unit's POWER switch or the
provided remote-control transmitter's
POWER key.
The maximum power (total power
consumption of components) that
can be connected to the SWITCHED
AC OUTLETS is 120 watts.
O ~ AN
Mono
The maximum power (total power
consumption of components) that can
be connected to the UNSWITCHED
AC OUTLET is 180 waits.