Harman Kardon AVR30 Owner's Manual page 18

SPEAKER BALANCE
ADJUSTMENT
This procedure gives the steps
necessary to adjust the sound
output level balance between the
front, center, and rear speakers.
After the adjustment is correctly
completed, the sound level heard
at the listening position will be the
same from each speaker. Taking
the time to do this setup will yield
the best performance possible out
of the Digital Signal Processor.
Set Master volume to the "Min"
position.
Master Volume
Min » e Max
Select the front speakers to be used.
Speaker
of A_B
A+B
17
Setup Adjustments
Set to the center position.
Bass Treble
e@ e
C) + J +
Set to the center position.
Balance
e
OC
Power on.
Loudness off.
Phono Loudness
il E rd
Audio Direct button off.
Audio Direct
Set Surround Mode to Dolby "Pro
Logic".
Surround Mode
Select the Center Mode.
Center Mode
Select the center mode depending
on your speaker configuration (see
Speaker Configuration section on
page 19). Details on the modes are
give in the Note below.
Notes for Center Mode
Selection
5 speaker Configurations
Normal: Select this mode when the
center speaker is smaller than the
other front speakers. In this mode
bass frequencies will come only from
the left and right front speakers.
Wide: Select this mode when the
center speaker is approximately the
same size as the other front
speakers. This mode sends bass
tones to all of the front speakers.
4 speaker Configurations
PHANTOM: Select this mode when
you do not have a center speaker.
In this mode, the center speaker
information will come from the left
and right front speakers.