Harman Kardon AVR30 Owner's Manual page 11

| Operating Instructions
Listening to Audio or
Video Sources
1. With Power on and the Master
Volume knob at minimum level,
select speaker setting A, B, both or
neither (for headphone use).
2. Press the "Listen to" button that
corresponds to the component you
wish to hear.
SAT TV Listen to| Tape f Tape 2
a a i ee
3. Begin playing the desired
component.
4. Adjust the Master Volume to the
desired level.
9. When listening at low volume,
you may wish to activate the
Loudness button. This boosts low
frequencies to improve the apparent
balance of low, mid and high
frequencies.
6. Adjust Bass and Treble controls
as desired.
Adjusting the AM/FM Tuner
With the "Tuner" Listen to button
selected:
5
1. Select AM or FM by pressing the
corresponding button.
2. Use the A and ¥ buttons to tune
to desired frequency. Or use the
station Preset buttons as shown
below.
3. When tuning FM stations, begin
with Seek-Stereo function on ("Seek"
will light on the Display Panel). In
this mode, pressing A (or ¥) will
tune your unit to the next higher (or
lower) strong station.
To tune to stations too weak to be
received in Seek-Stereo mode, turn
Seek-Stereo off. Then use A and VW
buttons to reach the desired
frequency.
NOTE: With Seek-Stereo off, all
broadcasts are received in mono
(this eliminates the excessive noise
that results when weak stations are
received in stereo). When you tune
to a new, stronger station, be sure to
turn Seek-Stereo back on.
Using the Preset Buttons
Your AVR30 allows you to store 16
station settings and quickly access
them, using the 8 Preset buttons
along with the Shift A-B button. The
Preset stations are designated by
the letter A or B, followed by a
number from 1 to 8. Any AM or FM
station can be stored in any preset
button.
Jo enter a station in "memory":
1. Tune to the desired station.
2. Be sure Seek-Stereo setting is
the one desired.
3. Press the Shift A-B button to
display the desired letter.
4. Press the Memory button
("Preset" will flash for about 8
seconds).
5. With "Preset" flashing, press the
desired numbered Preset button.
NOTE: When a station is set in
memory, the Seek-Stereo setting is
also saved. Subsequently, each
time a station is recalled using a
Preset button, the tuner
automatically switches to the original
seek-Stereo setting for that station.
To Change a preset station:
Simply enter the new station using
the "To enter a station in memory"
procedure above. The old station is
automatically erased.
To access a preset station:
Press the Shift A-B button to display
the correct letter. Then press the
desired numbered preset button.
NOTE: Preset stations are stored
indefinitely while the unit is
connected to a live AC source, and
for approximately 1 week when the
unit is unplugged.