Table of Contents
Advertisement
3) Press the OK soft key. You will hear a confirmation tone.
Setting up Voice Mail
If you subscribe to a voice mail service, you can use your phone to access your voice mailbox. The new message LED flashes
whenever you have messages waiting in your voice mailbox. If you have programmed your access number into your phone, you
[
can simply press the
provides you with the access number and the required voice mail signaling tone.
Setting the Voice Mail Signaling Tone
Your telephone service provider should provide you with the specifics of your voice mail service upon your enrollment. If you are
having trouble with your message waiting indicator on your phone not illuminating when you have waiting messages, you will
need to contact your service provider and inquire as to which type of message notification signal--either Frequency Shift Keying
(FSK) or Stutter Dial Tone (SDT)--their service uses.
If your voice mail service uses a FSK message signal to alert you of a new voice mail message, you will need to turn off the
Voice Mail Tone. If your voice mail service uses a SDT message signal to alert you of new voice mail messages, you can leave
the Voice Mail Tone on.
Follow the instructions below to set up your cordless phone settings:
1) Press the MENU soft key. Select the GLOBAL SETUP menu, then the VOICE MAIL TONE submenu.
2) Move the cursor to YES to set the voice message indication (SDT message signal) to ON or OFF.
3) Press the OK soft key. You hear a confirmation tone.
Programming One-Touch Voice Mail Access
You can program your voice mail access number to the
a button. Your voice mail service provider will supply you with the access number. This number may be simply a phone number.
To edit the voice mail number, follow the steps below:
1) Press the MENU soft key. Select HANDSET SETUP, then EDIT VOICE MAIL NO submenu.
2) Enter your personal access number (up to 20 digits).
3) If you need to have the phone wait before sending the next digits, press [redial/pause] or the PAUSE soft key to insert a two-
second pause in the dialing sequence. For a longer pause, press the key multiple times. A P appears in the display each time
you press the key and each pause counts as one digit.
4) Press the MENU soft key when you are finished.
Resetting the Voice Message Waiting Indicator
When you receive a new voice mail message, the LED on the top of the handset flashes. In the event your message alert tone
gets out of sync with your phone company's voice messaging system, you can reset back to its original "no messages waiting"
state. To reset, follow the steps below:
1) Press the MENU soft key. Select the GLOBAL SETUP menu, then the VMWI RESET submenu.
2) Move the cursor to YES.
3) Press the OK soft key. You hear a confirmation tone.
Adding Accessory Handsets
Your phone supports up to ten (10) handsets, including any handsets supplied with your phone. Accessory handsets do not
need to be connected to a phone jack. You can now place a fully-featured cordless handset anywhere AC power is available to
connect the handset charger.
Compatible Handsets
Your phone is compatible with the following Uniden 5.8 GHz Digital Accessory Handsets: TCX905, TCX400, TCX440, TCX450,
TWX977 and ELX500. (Please visit our website at
purchase an accessory or extra handset, you must register the handset to the original or main base before use. Accessory
handsets will not operate until they are registered.
Page 8 of 23
]
soft key to access your voice mail. When you subscribe to the service, your voice mail provider
[
]
soft key on a station so you can get your messages at the touch of
www.uniden.com
for the most up-to-date list of compatible handsets. If you
Advertisement
Table of Contents
