Supported Ata Commands - Seagate IRONWOLF NAS ST14000VN0008 Product Manual

www.seagate.com
Notes:
1. All pins are in a single row, with a 1.27mm (0.050") pitch.
2. The comments on the mating sequence apply to the case of backplane blindmate connector only. In this case, the
mating sequences are:
• the ground pins P4 and P12.
• the pre-charge power pins and the other ground pins.
• the signal pins and the rest of the power pins.
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a
blind-mate backplane configuration.
4. All used voltage pins (V
1.4.3

Supported ATA commands

The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA
commands, refer to the Serial ATA: High Speed Serialized AT Attachment specification.
on page 45
Table 9 Supported ATA commands
Command name
Accessible Max Address Configuration
Get Native Max Address Ext
Set Accessible Max Address Ext
Freeze Accessible Max Address Ext
Check Power Mode
Configure Stream
Download Microcode
Execute Device Diagnostics
Flush Cache
Flush Cache Extended
Get Physical Element Status
Identify Device
Idle
Idle Immediate
Read Buffer
Read DMA
Read DMA Extended
Read FPDMA Queued
Read Log DMA Ext
Read Log Ext
Read Multiple
Seagate IronWolf Serial ATA Product Manual, Rev. C
) must be terminated.
x
for details and subcommands used in the S.M.A.R.T. implementation.
78 / 0000
H
78 / 0001
H
78 / 0002
H
E5
H
51
H
92
H
90
H
E7
H
EA
H
12
H
EC
H
E3
H
E1
H
E4
H
C8
H
25
H
60
H
47
H
2F
H
C4
H
Command code (in hex)
H
H
H
Serial ATA (SATA) interface
See "S.M.A.R.T. commands"
26