Table of Contents
Advertisement
Selecting and setting a programme
Example in the diagram: programme for frozen joint of veal,
lean, 1.3 kg.
Press the
button.
`
1.
The first programme group and first programme appear.
3URJUDPPHV
3RXOWU\
&KLFNHQ IUHVK
Select the programme group by turning the rotary selector.
2.
3URJUDPPHV
9HDO
-RLQW IUHVK
Press the
button to change the line.
X
3.
Use the rotary selector to select the programme.
4.
3URJUDPPHV
9HDO
-RLQW IUR]HQ
In some of the programmes, you can make further
5.
specifications, e. g. Joint of veal option, followed by Lean joint
or Marbled joint. Press the
selection using the rotary selector.
3URJUDPPHV
-RLQW IUR]HQ
/HDQ MRLQW
Tips for the automatic programmes
The weight of the joint or poultry is
greater than the weight ranges
available.
The joint has cooked well, but the juices
are too dark.
The joint has cooked well, but the juices
are too clear and watery.
The joint is too dry on the top.
The joint looks good, but there was a
burning smell during roasting.
You wish to prepare frozen meat.
The meat is not cooked well enough or
is too well cooked.
button and make your
X
The weight range is deliberately limited. For very large joints, it is often impossible to
obtain a sufficiently large roasting dish. Prepare large pieces with
or
Hot air grilling.
4
Select a smaller dish or use more liquid.
Select a larger dish or use less liquid.
Use a dish with a tightly fitting lid. Very lean meat will remain more succulent if it is
covered with rashers of bacon.
The lid of the roasting dish is not closed properly, or the meat has expanded and has
pushed up the lid. Always use the right lid for your ovenware. Make sure that there is at
least 3 cm between the meat and the lid.
Season frozen meat in the same way as fresh meat. Caution: For frozen meat it is not
possible to delay the end time. The meat would defrost during the waiting time and would
be inedible.
Change the settings the next time. You will find information on this in the Automatic
programmes, Individual Settings section.
Press the
X
button.
6.
A suggested weight appears for the programme selected.
Use the rotary selector to specify the weight of the dish.
7.
3URJUDPPHV
/HDQ MRLQW
J
Press the
n
button.
8.
The programme starts. You can see the cooking time
counting down in the status bar.
The programme has ended
A signal sounds. The oven stops heating. You can cancel the
signal earlier by pressing the
time in the status bar is 00:00:00.
Cancelling the programme
Press and hold the
button until 3D hot air, 160 °C appears.
n
You can now change the settings.
Calling up information
Before starting: Press the
information, press the
button again.
°
Setting a later end time
See the section entitled Time-setting options - Setting a later
end time.
Adapting to individual requirements
If the cooking result of a particular programme does not meet
your expectations, you can adapt it to your requirements the
next time.
Adjust the settings as described in points 1 to 7.
Then press the
button and move the illuminated field using
X
the rotary selector.
-
+
ÛÛÛÚÛÛÛ
To the left = weaker cooking result.
To the right = cooking result more well done.
The cooking time for the programme changes.
button. The elapsed cooking
0
°
button briefly. To view each item of
%
Top/bottom heating
25
Advertisement
Table of Contents
