National Instruments PXI-8221 User Manual page 16

© National Instruments Corporation
9. Check the installation.
10. Connect the keyboard and mouse to the appropriate connectors. If you
are using a PS/2 keyboard and a PS/2 mouse, use the Y-splitter adapter
(refer to Figure 4-1,
connect both to the PS/2 connector.
11. Connect the VGA monitor video cable to the VGA connector.
12. Connect devices to ports as required by your system configuration.
13. Power on the chassis.
14. Verify that the controller boots. If the controller does not boot, refer to
the What if the NI PXI-8183 does not boot?
Troubleshooting.
Figure 2-2 shows an NI PXI-8183 installed in the system controller slot of
a National Instruments PXI-1036 chassis. You can place PXI devices in any
other slot.
1
2
1 PXI-1036 Chassis
Figure 2-2. NI PXI-8183 Controller Installed in a PXI Chassis
Chapter 2
Y-Splitter Cable) included with your controller to
3
2 NI PXI-8183 Controller
2-3
Installation and Configuration
section of Chapter 5,
3 Injector/Ejector Rail
NI PXI-8183 User Manual